Products #

URLs: /products (list), /products/new, /products/{id}, /products/{id}/edit, /products/{id}/stations (the Stations tab as its own URL — bookmarkable)

A product is a DUT under test — its part number, revision, characteristics (named measurements with limits and units), and pin map. The Products entity pages are the browser surface for the project's products/ directory.

List — `/products` #

A table with one row per product. Columns:

Column	What it shows
ID	Product identifier
Name	Human-readable name
Rev	Revision string (when set)
Chars	Count of characteristics defined on the product
Runs	Total runs that have tested this product
Passed	Run count with outcome `passed`
Failed	Run count with outcome `failed`
Last Run	Most recent run start timestamp, browser-local time

Click a row to open /products/{id} (detail). When no products exist, the table is replaced with a card hinting at the products/ directory and the New Product button.

Detail — `/products/{id}` #

A header bar (Back + Edit buttons), one Product Information card (ID, name, revision, description), then a tab strip with three tabs:

Tab	Content
Pins	The DUT pin map (one row per pin: pin, signal, description)
Characteristics	One row per characteristic: name, function, direction, units, limit shape
Stations	Compatible stations + the required capabilities the matcher resolved against. Each entry is a card with a View button that opens the matching station detail page.

When the URL points at a missing product, the page shows a "Product not found." card.

Edit — `/products/{id}/edit` #

A header bar with the product name + a "Changes auto-saved" hint (no Save button), then a tab strip with three tabs:

Tab	Content
Info	Name / Description / Revision (Product ID is read-only)
Pins	Per-pin rows — add, remove, or edit pin / signal / description
Characteristics	Existing characteristics show Function / Direction / Units as a read-only summary; the Add Characteristic dialog is where you set those fields on new entries.

New — `/products/new` #

Different shape from Edit — a single non-tabbed form with just Product ID, Name, and Description fields. After creation, the page redirects to /products/{id}/edit so you can add pins and characteristics in their dedicated tabs.

Underlying data #

Products are stored as YAML — either flat (products/<id>.yaml) or in a per-product subdirectory (products/<id>/<id>.yaml); both layouts are supported.

For the YAML schema, see Configuration reference → Products. For the concept, see Concepts → Products.

Common tasks #

Add a characteristic — open /products/{id}/edit, switch to the Characteristics tab, click Add. The dialog captures name, function, direction, and units. Limits and tolerance bands are set in the product YAML, not in this UI — edit the YAML in products/<id>/<id>.yaml (or the flat-layout equivalent) and the Detail page picks them up on next load.
Check which stations can run this product — pre-fill the Launch Test page with ?product=<id> and read the Station hint.

Products #

List — /products #

Detail — /products/{id} #

Edit — /products/{id}/edit #

New — /products/new #